Winter season almost over, Summers is about to begin. Heat increases every day so what we do this time? We cannot remove it in our summer season. We can do our air is some cooling. The rich country uses always Air-conditioner but poor countries cannot buy this. Today we learn how we make from a normal to air cooler. It not more cost and easy everyone can make this easier. So we start to make our homemade air cooler.
What will it take to make an air cooler?
- 3 Meter copper pipe you can collect from the electronic market
- One good speed table fan
- 1 Meter rubber pipe the same for connecting with copper pipe.
- One small water pump, the same as an aquarium water pump. You can buy from the electronic market and it’s price note more than 1$ dollar.
- We need also a plastic pot for putting water.
- Some Ice can make more cooling air.
- Mobile charger or torchlight charger.
If you collect all these accessaries ok you can start making cooler. First, fasten the copper pipes to the fan front sight cover. Carefully fasten the copper pipes are arranged neatly from one end to the other, the wind can go well. After this work finish, we put this fan cover with a fan. Our first step work is finished
Properly you can check to make our picture. Your fan cover is small you need maybe a 2-meter copper pipe and your fan is big this time need copper 3 meters. Now we cut rubber pipe we cut this one is 40cm another is 60cm. We fasten a 40cm rubber pipe with a wireless pipe and a big 60 cm pipe with the outside pipe. 60cm rubber pipe another side we connect a water pump with motor. You check this motor has two cable one is red and another is white or yellow or maybe black. Take your mobile or torchlight charger one cable red is connected with a red cable and black is connected with black color, sometimes you see only (+) or (-) this time connect red one with plus and minus(-) black cable connect with this.
Now we take a water pot for which water pot we can put minimum 5L water. After 5 liters when we put this pot water level come centerline. Now we put here some ice it’s for water cooling 1 Kg size is better but small also no problem. Our maximum work is finish and now we put here a water pump and which one which rubber pipe is 60cm and where we connect motor this side. This side water is pump motor and goes the other side. Another side rubber pump we put this put because one side water pump and again come here no need more water this one is enough and we need to put ice when finish one another one put. Ready your cooler and you can or switch on the water pump the same time you start your fan gives now cooling air. You now successfully make your water cooler. Thanks for reading full article and comment please if you do not understand you can see the full video here.
We have always published here technology tips and news and you can learn and more benefit.